Follow SRS Crisafulli

New and Used Equipment

Trailer pumps

Crisafulli Trailer Pumps
move high volumes of water

8", 10", 12" and 16" Humpback trailer pumps in stock now!

 The volute and impeller are mounted on a 21' long, single axle humpback trailer with a heavy duty driveshaft supported by four sealed, anti-friction ball bearings, with remote grease lines extended to the front of the pump, telescopic PTO shaft, pin-type hitch, trailer jack and an 18' long discharge pipe with an oval band to adapt to Crisafulli discharge tubing.


Remote Control FLUMP Dredge 

FLUMP ST-3 Standard duty dredge, USED

  • 3" S-series pump with 4" or 6" discharge
  • 10' (3 m) dredging depth
  • 4.5' (1.4 m) cutterhead width
  • 25 HP, TEFC pump motor
  • Power:  3 phase, 460 volt, 60 Hz, 100 KVA
  • Handheld radio remote control
  • 500' power cable with quick disconnects
  • Est. hours:  approx. 600, built 8/2008

Remote Control FLUMP Dredge  Available
FLUMP
, 4" Severe Duty dredge, USED
  • 4” J-series pump with 6” discharge
  • 12’ (3.7 m) dredging depth
  • 4.5’ (1.4 m) cutterhead width
  • 50 hp, TEFC pump motor
  • Power: 3 phase, 460 volt, 125 KVA
  • Handheld radio remote control
  • 500’power cable with quick disconnects

 

Some images are not actual.

 

Rotomite SD-110 Dredge

Perfect for marinas, lakes, and ponds

This unit is currently rented.

  • 4" J-Series pump with 6" discharge
  • 12' (3.6 m) dredging depth
  • 1,475 gpm at 123' TDH
  • Up to 85 cubic yards (65 cubic meters) sludge/hour
  • Draft 17 inches (43 cm)
  • Dredge cutterhead width 8.5' (2.6 m)
  • Ultrasonic digital flowmeter
  • Self-propelled; no need for cable traversing

Crisafulli Submersible Hydraulic Pumps

Crisafulli Submersible Hydraulic Pumps (2)
For a wide range of pumping applications

One available, NEW:

  • 3" S-Series pump with 8" diameter impeller
  • Requires 18 gpm at 1400 psi

One available, USED (in good condition):

  • 4" S-Series pump with 10" dia. impeller
  • Requires 54 gpm at 2000 ps

Ready to ship immediately, give us a call today!


GEDC0749 resized 600

New Crisafulli Hydralic Power Unit PUDH-225
Hydraulic power delivered anywhere

  • John Deere Diesel 165 HP @ 2,000 rpm
  • Primary circuit 55 GPM @ 3,400 PSI
  • Secondary circuit 10 GPM @ 2,400 PSI
  • Skid mounted
  • 50 gallon hydraulic fluid reservoir
  • Emergency safety shutdowns
  • Cold weather package, block heater, air intake heater